This resets the BIOS to how it was when it left the factory. that's nuts), put the battery back in, and plug the computer back in. Similar steps Unplug the computer, remove the battery for a couple seconds (some people will say minutes. Many people will just pull the battery instead. Short the 2 pins for a couple seconds and then plug the computer back in and turn on. Even when a computer is shutdown, there is still power to the motherboard.Ĭlearing the BIOS is described on page 1-3. Something else may have been knocked loose.Īdding and removing memory sticks is a pretty safe thing, but one should ensure the power to the computer is off (ie, PSU unplugged).The memory slots are very close to the GPU slot on that board. Did you knock the GPU out of it's socket when working.Because that CPU has no integrated GPU, the on-board HDMI (or DVI) would give you no signal. Refer to the display adapter method above. The Control Panel does not display graphics memory information. Alternative methods for determining graphics memory From the list below, choose the version of the Control Panel currently configured on your system. Did you plug your monitor into the HDMI (I assume) on the motherboard or the video card. Figure 1: Graphics memory as seen from the Adapter tab. ![]() Mixing memory can lead to issues, but I have also often seen memory sticks that were not seated all the way causing the start, run for 2 seconds, and restart symptom you describe. In the event that you remove the digital display adapter board and do not replace it, you must reinstall the panel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |